I stock all components for the Saturn, Warn, Husky, Selectro and Dualamatic Overdrives applicable for installation in the Dana 18 transfer case.  I also purchase inventories of the same parts in any condition.  I can rebuild your overdrive for a flat fee of $45 labor plus parts and shipping charges.  Except for shipping expenses, there is never a charge for an estimate on a rebuild or repair.

I also offer rebuild services with flat fee labor for the following drivetrain components:

T-84, T-86 and T-90 Transmissions - $100 labor total plus parts
T14, T-15 and T-150 Transmissions - $110 labor total plus parts
Dana 18 and Dana 20 Transfer Cases - $110 labor total plus parts

Please contact me for an estimate on shipping, which I am able to keep very reasonable.

Rebuild kits are also available for the same transmissions and transfer cases.  Included are a small parts kit, front and rear bearings, cluster shaft, gaskets, and seals.  Call for price.

T90 Basic Rebuild Kit - $90

The basic rebuild kit includes cluster shaft, synchro rings, shift dogs, shift springs, snap rings, oil retainer shield, needle bearings, spacers, and detent balls for side shift transmissions, not shown.


T90 Master Rebuild Kit - $185

The master rebuild kit includes all of the parts in the basic rebuild kit plus a new 2nd gear and a new 2nd-3rd gear complete syncromesh assembly.


T14 Rebuild Kit - Similar to above - With cluster shaft and synchro rings - $120

T15 Rebuild Kit - Similar to above - With cluster shaft and synchro rings - $125

T150 Rebuild Kit - Similar to above - With cluster shaft and synchro rings - $120

Dana 18 Rebuild Kit - All years and applications available - All kits contain all necessary gaskets, rubber seals, felt seals, tapered bearings and races, ball bearing, thrust washer, snap ring, and output shaft bushing.

3/4" Shaft - $109  (Not shown)
1-1/8" Shaft - $105
1-1/4" Shaft - $90 (Not Shown)
 






Dana 18 Intermediate Shaft Repair Kit - Included with Rebuild Kit shown above.  Can be replaced in-vehicle with parking brake assembly removed.

3/4" Shaft - $60          
1-1/8" Shaft - $50         
1-1/4" Shaft - $40         




SM420 Rebuild Kit - $137.50 (Synchro rings not included, available separately)


SM-420 Synchro Rings ( 2 only ) add $25.00

SM465 Rebuild Kit - Similar To Above, Not Shown - $115.54 (Synchro rings not included, available separately)

SM-465 Synchro rings ( 3 only ) add $35.00


PTO Winches

I  carry parts for and rebuild Ramsey and Koenig PTO Winches.  

PTO Drive Units

I also rebuild and have parts for Power Take Off drive units from Koenig, Ramsey and Spicer.

 

Ramsey Replacement Handle Kit - $35

Includes the following, new handle, knob, support pin, lower mounting plate, upper mounting plate and felt seal.

Koenig Replacement Handle Kit - $35

Includes the following, new handle, knob, support pin, lower mounting plate, upper mounting plate and felt seal.

Spicer Replacement Handle Kit - $35

Includes the following, new handle, knob, support pin, lower mounting plate, upper mounting plate and felt seal.